Delta Electronics VFD-XXXM Parameter, Explanation, Settings, Factory, Customer, English-11

Parameter	Explanation	Settings	Factory	Customer
			Setting
		00: M0: FWD/STOP, M1: REV/STOP
Pr.38	Multi-function Input	01: M0: RUN/STOP, M1: REV/FWD	00
	Terminal (M0,M1)	02: M0, M1, M2: 3-wire operation control
		mode
		00: No Function
		01: Output OFF (N.O.) (enabled when
		running)
		02: Output OFF (N.C.) (enabled when
		running)
		03: External Fault (normally open) N.O.
		04: External Fault (normally close) N.C
		05: RESET
		06: Multi-Step Speed Command 1
		07: Multi-Step Speed Command 2
		08: Multi-Step Speed Command 3
		09: Jog Operation
		10: Accel/Decel Speed Inhibit
		11: First or Second Accel/Decel Time
		12: Base-block (B.B.) (N.O)
Pr.39	Multi-function Input	13: Base-block (B.B.) (N.C)	05
	Terminal (M2)	14: Increase Master Frequency
		15: Decrease Master Frequency
Pr.40	Multi-function Input	16: Run PLC Program	06
	Terminal (M3)	17: Pause PLC
		18: Counter Trigger Signal
Pr.41	Multi-function Input	19: Counter Reset	07
	Terminal (M4)	20: No function
		21: RESET command (N.C)
Pr.42	Multi-function Input	22: Control source: External Terminal	08
	Terminal (M5)	23: Control source: Keypad
		24: Control source: Communication
		25: Parameter Lock (Write disable, Read
		is always 0)
		26: PID Disable (N.O.)
		27: PID Disable (N.C.)
		28: Second Source for Frequency
		Command
		29: Forward (contact is open) / Reverse
		(contact is close)
		30: One-Shot PLC Run
		31: Index input signal
		32: Counter Incremented by Drive Output
		Frequency
		00: Analog Frequency Meter (0 to
		Maximum Output Frequency)
Pr.43	Analog Output Signal	01: Analog Current Meter (0 to 250% of	00
		the rated AC drive current)
		02: Feedback signal (0 - 100%)
		03: Output power (0 - 100%)
Pr.44	Analog Output Gain	00 to 200 %	100

English-11