Denon AVR-1403, 483 manual Comp. Off, Default, Surround parameters w Cinema EQ. Cinema Equalizer

ENGLISH

6	Use the	(left) and	(right) buttons to set the D. COMP.
			(Initial)
			OFF	LOW	MID	HIGH
	(Remote control unit)	D.COMP. OFF
			(left) button		(right) button
	SURROUND				NOTE:

MENU

Press the SURROUND or	(down) button to switch to the LFE This parameter is not displayed
setting.	during DTS playback.

(Remote control unit)

7 Use the (left) and (right) buttons to set the LFE level.

LFE 0dB

(Remote control unit)

•The level can be adjusted in units of 1 dB from –10 to 0 dB.

Set to the desired level according to the speaker systems being used and the source to be played.

	SURROUND
	Press the SURROUND or	(down) button to switch to the default setting.
	MENU
8	(Remote control unit)
	To reset the settings to the factory defaults, use the			(left) and	(right) buttons to display “Yes”.
	DEFAULT		Y/N		YES	NO
	(Remote control unit)			(left) button		(right) button

SURROUND

Press the SURROUND or (down) button to switch to the CINEMA EQ. setting.

MENU

(Remote control unit)

NOTE:

•When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the setting will be completed.

Surround parameters w

CINEMA EQ. (Cinema Equalizer):

The Cinema EQ function gently decreases the level of the extreme high frequencies, compensating for overly-bright sounding motion picture soundtracks. Select this function if the sound from the front speakers is too bright.

This function only works in the Dolby Pro Logic, Dolby Digital and DTS Surroundmodes. (The same contents are set for all operating modes.)

D.COMP. (Dynamic Range Compression):

Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud sounds). For listening late at night, or whenever the maximum sound level is lower than usual, the Dynamic Range Compression allows you to hear all of the sounds in the soundtrack (but with reduced dynamic range). (This only works when playing program sources recorded in Dolby Digital.) Select one of the four parameters (“OFF”, “LOW”, “MID” (middle) or “HI” (high)). Set to OFF for normal listening.

LFE (Low Frequency Effect):

Program source and adjustment range

1.Dolby Digital: –10 dB to 0 dB

2.DTS Surround: –10 dB to 0 dB

When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct Dolby Digital playback.

When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback. When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to -10 dB for correct DTS playback.

33