ENGLISH

Easy Setup and Operation

Starting Auto Setup

1 Press the CURSOR F button to start the Auto

Setup.

• Start the measurements.

Auto Set <Start

Measurement of each channel is performed as follows:

1

2

3

FL FR

C SW SL

SR SBL SBR

1: Only the front speakers (A) are measured, front speakers

(B)are not available. Even if the front speakers (B) are set, the setting automatically switches to the front speakers (A) once measurements are completed.

2: The subwoofer speaker is measured twice.

3: When “ZONE2” is selected, this is not displayed ( page 43).

After each channel is measured, “Calculating” appears. The display switches to the speaker check display automatically.

Measure:FL <Ccl

Calculating

Speaker:3/4/.1

2Check the results of the speaker detection

Example: 7.1-channel systems

Speaker:3/4/.1

Subwoofer

Surround and Surround back speaker

Front and Center speaker

2 Press the CURSOR D or H button to select “Store”, then press the CURSOR F button.

Store:

Store the checked measurement values.

All parameters are stored.

Cancel:

Cancel the checked measurement values.

Setup <Store

Storing

3 Disconnect the setup mic to finish Auto Setup.

Easy Setup and Operation

2About automatic retry

To confirm the results of the measurements, remeasurement is automatically performed.

Remeasurement is performed up to 2 times. During this time, “Retry1” or “Retry2” is displayed on the display.

Overload Retry1

NOTE:

•When measurements have been made using the measurement microphone, speakers with built-in filters, such as a subwoofer, might be set to a value that differs from the physical distance because of the internal electrical delay.

•Measurement is cancelled if the MASTER VOLUME control knob is operated while the Auto Setup is performed.

•If the output volume and crossover frequency of your subwoofer speaker can be changed, then set the volume to halfway and the crossover filter to maximum or switch off the low-pass filter.

•The speaker configuration, delay time and channel level measurement values can be checked using the system

setup function ( page 38 ~ 41).

9

ENGLISH