Easy Setup and Operation
About error messages
•These error displays may be displayed when performing Auto Setup measurement and the automatic measurements can not be completed because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent items, and measure again.
•When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the measurements when the noise level is low, or switch off the power of the equipment that is producing the noise for the duration of the measurements.
Press the CURSOR D or H button to select the items, then press the CURSOR F button.
| Display example |
|
| Cause | Measures | |
|
|
|
| q The speakers required for producing suitable | • Check that the pertinent speakers | |
|
|
|
| reproduction have not been detected. | are properly connected. | |
|
|
|
| • The front L or front R speaker was not |
| |
|
|
|
| |||
| Caution:SP None |
| properly detected. |
| ||
|
| • Only one channel of the surround speakers |
| |||
|
|
|
|
| ||
|
|
|
| was detected. |
| |
|
|
|
| • Sound was output from the R channel when |
| |
|
|
|
| |||
| FL |
|
| only one | surround back speaker was |
|
|
|
| connected. |
|
| |
|
|
|
|
|
| |
|
|
|
|
| ||
|
|
|
| • The surround back speaker was detected, but |
| |
|
|
|
| the surround speaker was not detected. |
| |
|
|
|
|
|
| |
|
|
|
| w The speaker polarity is connected in reverse. | • Check the polarity of the pertinent | |
|
|
| ||||
| Caution | :Phase |
|
|
| speakers. For some speakers, this |
|
|
|
| display may be displayed even | ||
|
|
|
|
|
| |
|
|
|
|
|
| though the speakers are properly |
|
|
|
|
|
| connected. If so, select “Skip0”. |
| FL/R |
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
| e When accurate measurements cannot be | • Set up the speakers so that their | |
|
|
| ||||
| Caution |
| made due to the input level of the microphone | position is farther away from the | ||
|
| being too high. | listening position. | |||
|
|
|
| |||
|
|
|
|
|
| • Lower the volume of the subwoofer |
|
|
|
|
|
| speaker. |
| Overload | <Exit |
|
|
| |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ENGLISH
Easy Setup and Operation
Playing a DVD with surround sound
1 Disconnect the microphone from the unit.
2 Select the input source to be played.
3 Select the play (surround) mode.
4 Start DVD playback.
5 Adjust the volume.
10
ENGLISH