ENGLISH

Advanced Operation

INPUT SELECTOR

POWER SPEAKER

Other functions

Recording the program source (recording the source currently being monitored)

1 Select the input source to be played.

2 Select the input mode and play (surround) mode.

3 Start recording on the tape or video deck.

For instructions, refer to the component’s operating instructions.

•The AUDIO IN’s signal selected with the INPUT SELECTOR knob are output to the CDR/TAPE and VCR AUDIO OUT terminals.

2Simultaneous recording

The signals of the source selected with the INPUT SELECTOR knob are output simultaneously to the CDR/TAPE and VCR REC OUT terminals. If a total of two tape and/or video decks are connected and set to the recording mode, the same source can be recorded simultaneously on every decks.

Last function memory

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit’s POWER switch is off and the power supply cord disconnected.

Advanced Operation

Initialization of the microprocessor

If the indication on the display is not normal or if the operation of the unit is not correct, then the microprocessor should be reset by the following procedure.

1 Switch off the unit using the main unit’s POWER switch.

2 Keep both SPEAKER A and B buttons depressed and turn on the unit by pressing the main unit’s POWER switch.

3 Check that the entire display is flashing at 1- second intervals and release the buttons.

•The microprocessor will be initialized.

•If step 3 does not work, start over from step 1.

•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).

37

ENGLISH