Denon DN-A7100 manual English, ¤1 MEMO/HT-EQbutton

¤1 MEMO/HT-EQ button

(When TUNER mode is selected)

This button is used to store setting to memory or program a source.

(When AMP mode is selected)

Used to turn on or off HT(Home Theater)-EQ mode. This mode compensates for the audio portion of a movie sounding “bright”.

When this button is pressed, “EQ” indicator light up.

¤2 A/D button

(When AMP mode is selected)

Used to switch between the analog and digital inputs.

¤3 TUNING +/– buttons

(When TUNER mode is selected)

Used to tune a frequency station up and down.

¤4 MENU button

(When AMP mode is selected)

This button is used to call up the SETUP MAIN MENU of the DN-A7100.

¤5 VOLUME +/– buttons

This button is used to adjust the volume for the amplifier.

¤6 EXIT button

(When AMP mode is selected)

This button is used to cancel setting in the setup menu.

¤7 MUTE button

This button is used to mute the audio for the amplifier.

¤8 ATT button

(When AMP mode is selected)

When the input signal is too high and the voice distorts even by throttling the DN-A7100 VOLUME control, turn on this function.

“ATT” is indicated when this function is activated. The input level reduced. Attenuator is invalid for the output signal of “REC OUT”.

Note:

This function is unavailable while the digital input is selected.

¤9 TREBLE +/- buttons

These buttons are used to adjust the tone control of high frequency sound for left and right speaker.

‹0 T-DISP button

(When TUNER mode is selected) Used to select the display mode in RDS.

‹1 PTY/V-OFF buton

(When TUNER mode is selected)

Used to display the programme type information of the current station.

(When AMP mode is selected)

Used to turn off the video signal.

‹2 Infrared Transmitter

This transmitter emits infrared light. Press the buttons while pointing the transmitter towards the infrared receiver window of the DN-A7100.

ENGLISH

9