English, Recording An Analog Source, Ch Input

RECORDING AN ANALOG SOURCE

In normal operation, the audio or video source selected for listening through the DN-A7100 is sent to the record outputs.

This means that any program you are watching or listening to may be recorded simply by placing machines connected to the outputs for TAPE OUT, CD-R/MD OUT, VCR OUT in the record mode.

To record the input source signal you are currently watching or listening to

1. Select the input source to record by turning the INPUT SOURCE knob on the front panel or simply press the input selector buttons on the remote.

The input source is now selected and you may watch or listen to it as desired.

2. The currently selected input source signal is output to the TAPE OUT, CD-R/MD OUT, VCR OUT outputs for recording.

3. Start recording to the recording component as desired.

Recording the video from one source and the audio from another

You can add the sound from one source to the video of another source to make your own video recordings.

Below is an example of recording the sound from a compact disc player connected to CD IN and the video from a video camera connected to DSS/VCR2 to video cassette recorder connected to the VCR OUT jack.

1.Switch the video output source to VCR1 by simply pressing the input selector buttons on the remote.

2.Switch the audio input source to CD by simply pressing the input selector buttons on the remote.

3.Now “CD” has been selected as the audio input source and “VCR1” as the video input source.

Notes:

•If you change the input source during recording, you will record the signals from the newly selected input source.

•You cannot record the surround effects.

•Digital input signals are only output to the digital outputs. There is no conversion from digital to analog.

When connecting CD players and other digital components, do not connect only the digital terminals, but the analog ones as well.

HT-EQ (HOME THEATER EQUALIZER)

At cinemas, the front left, front right and center speakers are located behind the screen. So, screen damping is taken into account when mastering movie software, with an emphasis on high frequencies. When playing back such software at home, the signal takes on different characteristics from those at the cinema. This unit includes HT-EQ to rectify the sound difference between that experienced at a cinema and in a home theater, allowing you to enjoy the same sound you would experience at the cinema at home. The HT-EQ feature is available except in the following modes.

•7.1 CH INPUT

•PURE-DIRECT

•When VIRTUAL is set for the surround mode

1.Press the HT-EQ button on the unit.

“EQ” indicator on the front panel will illuminate, indicating the HOME THEATER EQUALIZER has been activated.

2.To cancel this function, press the HT-EQ button again.

“EQ” indicator on the front panel will be turned off, indicating the HOME THEATER EQUALIZER has been deactivated.

7.1 CH INPUT

The DN-A7100 is equipped for future expansion through the use of Multi channel Super Audio CD multichannel player or DVD-Audio player.

When this is selected, the input signals connected to the L(front left), R (front right), CENTER, SL (surround left), SR (surround right) and SBL (surround back left) and SBR (surround back right) channels of the 7.1 CH. In jacks are output directly to the front (left and right), center, surround (left and right) and surround back the pre-out jacks without passing through the surround circuitry.

When 7.1 CH. INPUT is selected, the last video input used remains routed to the Monitor Outputs.

This permits simultaneous viewing with video sources.

1. 4.

3. 1.