Denon DN-X1600 owner manual Troubleshooting

					ENGLISH
Troubleshooting						Getting
						Started
n Are all the parts connected properly?				n DN-X1600 does not operate normally or no sound is produced
n Have the operations been performed properly according to the owner’s				• Are the USB cable, audio cables, etc., properly connected?
						Connections
manual?				• Is the appropriate device selected on your audio application?
				• Is the volume setting for the source, audio device, application, OS, etc., properly
n Are the amplifier and speakers operating properly?				raised?
If the unit fails to operate properly, check out the remedial action in the table below according to the				• Is the sampling frequency setting appropriate?
						Basic
symptoms present, and see if this fixes the problem.
Types of trouble which are not described in the table below may indicate trouble in the unit itself so consult				Either make the same settings in the DN-X1600’s preset mode and on the application.
with your dealer from whom you purchased the unit. If your dealer does not know what action to take,				• Are there WAV files with different sampling frequencies and bit rates?		Operations
contact one of our customer service centers or your nearest repair service center.
Service centers are listed at http://www.d-mpro.com.				Depending on your audio application, it may not be possible to play WAV files with
				different sampling frequencies and bit rates simultaneously.
Symptom	Cause	Remedy	Page			Effector
				If other USB devices are connected, try connecting only DN-X1600 to check for
turn on.	to the power outlet.	the power outlet.
				• Is other USB equipment in use?
The power fails to	• The AC power cable is not connected	• Connect the AC power cable to	9			Function
				problems.
No sound is heard	• One or more of the connecting cables	• Check the cable connections.	7
				• Is the USB connector of the connected computer compatible with USB 2.0
or the volume	have not been connected properly.
level is low.	• The SOURCE SEL LN1/LN2/LN3/	• Set the SOURCE SEL LN1/LN2/	10	(Hi-Speed)?
	LN4/USB/P1–4controls have not	LN3/LN4/USB/P1–4 controls to		Use a USB 2.0-compatible cable.		Fader
	been set to the correct positions.	the position which corresponds
		to the component now playing.		n Sound is broken or distorted		Start
	• The ducking function of the	• Set the DUCKING ON/OFF	11
	microphone has been activated.	button to the OFF position.		• Are other applications or device drivers operating?
						USB
The sound is	• The master output audio level is too	• Adjust the MASTER LEVEL	10	Close any unneeded applications.
distorted.	high.	control.		• Are you playing multiple WAV files?
	• The input level is too high.	• Adjust the channel input LEVEL	10			Utility
				When playing multiple WAV files simultaneously, depending on the capacity of your
		controls.
				computer, the sound may be broken.
The fader start	• One or more of the connecting cables	• Connect the CD player to the unit	7
of the CD player	have not been connected properly.	using the stereo mini jacks.				Specifi
cannot be	• The CH FADER START switch and	• Set the CH FADER START switch	14, 15
initiated.	CROSSFADER START switch have	and CROSSFADER START				cations
	not been set to the ON position.	switch to the ON position.
						Troubleshooting

27