Denon DJ DN-X1700 USB Settings, Selecting the USB mode USB audio, Setting the USB audio input

USB Settings

Getting Started

Selecting the USB mode

USB audio Setting the USB audio input

The respective functions given below are carried out in the operation modes of the USB A terminal (USB host mode) and USB B terminal (USB device mode).

USB A :

•Preset data import/export function

•Version upgrading

USB B :

•USB audio interface function

•USB MIDI interface function

The operation mode to be established when the unit's power is turned on can be selected by a Utility setting. (Factory setting: USB A)

To switch from USB A (host mode) to USB B (device mode):

1 Press the UTILITY/–USB A/USB B button for one second.

2Operation now transfers to the screen shown below.

3(EFX2), and press the button to enter the selection.Select OK/Cancel using the EFX SELECT control

4device mode is established.

(* When a specific period of time elapses with no computer connected to the USB B terminal, the

indicator changes back to USB-A, and the host mode is automatically selected.)The indicator changes from USB-A to USB-B, and the

5A/USB B button for one second, and select the settings by following the same steps.To select the host mode again, press the UTILITY/–USB

This unit features a 24-bit 96 kHz USB audio input/output sound card function which supports up to 8 channels (4 stereo systems). The sampling frequency can be set to 44.1 kHz, 48 kHz or 96 kHz using a Utility setting (factory setting: 96 kHz).

*When the unit is connected to a computer which runs Windows XP, Vista or a similar operating system, install DENON DJ ASIO driver Ver2 contained on the CD-ROM provided. If the Ver1 driver is already installed, first uninstall it, and then install the Ver2 driver.

*Depending on the computer used, select the PC/MAC section settings under System Setting among the Utility settings.

Setting the USB audio output

Any sound source of the 4 systems provided—1 to 4 input channels (Pre EQ), mic input (Post Send VR), master output (Pre Limiter) or REC output—can be selected as the USB audio output.

The USB audio output level can be adjusted using a Utility setting.

1 Press the UTILITY/–USB A/USB B button. The Utility setting screen is displayed.

Using the EFX SELECT control (EFX2), select Audio

2 Setting USB Audio Setting Output Source Select. One of the audio sources assigned to the USB output channels is selected on the selection screen displayed.

Press the UTILITY/–USB	A/USB B button. The Utility
3 setting screen is closed.

One of the two modes below is set using the USB ASSIGN CH/MASTER button for the USB audio input assignment destinations.

The LED on the side corresponding to the mode selected lights.

The USB audio input levels can be adjusted using Utility settings. The adjustment values are stored on a mode by mode basis.

q CH INPUT mode

Select this mode when mixing sound using only the DN-X1700 without using the mixer functions of the DJ software.

The USB audio input signals are assigned using the configuration shown below.

USB channel 1 and 2 inputs Input channel 1

USB channel 3 and 4 inputs Input channel 2

USB channel 5 and 6 inputs Input channel 3

USB channel 7 and 8 inputs Input channel 4

w MASTER mode

Select this mode when using both the mixer functions of the DJ software and the DN-X1700’s functions.

The USB audio input signals are assigned to the buses shown below.

USB channel 1 and 2 inputs Master bus

USB channel 3 and 4 inputs Cue monitor bus

USB channel 5 and 6 inputs Disabled

USB channel 7 and 8 inputs Disabled

The mixer output of the DJ software is mixed in the buses using the DN-X1700.

*Ensure that the audio output settings of the DJ software correspond to the specifications given above.

Connections Basic Operations Effector Function Fader Start USB Utility Specifications Troubleshooting

13