Rear Panel
Q6 r | e | w | q |
| Q3 | Q4 |
|
|
|
|
|
| PUSH |
t y |
| u i | o | Q0 Q1 | Q2 | Q5 |
qPHONO 1, 2, 3, 4 /CD 1, 2, 3, 4 input terminals | yUSB A terminal |
|
| |||
Q1BOOTH OUT (BALANCED) connectors
These TRS terminals are balanced line output terminals whose signal levels are adjusted using the BOOTH LEVEL control provided on the top panel.
Pin layout (TRS):
Tip: Hot, Ring: Cold, Sleeve: GND
Q2SEND/Q3RETURN terminals
•These 1/4” TS mono terminals allow external processing of the program signal.
•When connect monaural type effect processor, use Lch input and output.
SEND (output):
Connect this to the input terminal on the external effector.
RETURN (input):
Connect this to the output terminal on the external effector.
Q4MIC1 input terminal
A microphone is connected to this balanced combo jack with XLR connector or with
Getting Started Connections Basic Operations Effector Function
These unbalanced stereo RCA terminals are used to connect devices such as a turntable (RIAA) with an MM (moving magnet) type of cartridge or CD/Media Player.
wDIGITAL IN 1, 2, 3, 4 input terminals
These are used to connect the digital output terminals of CD/Media Players and digital players.
eCOAXIAL DIGITAL OUT terminal (44.1/ 48/ 96kHz)
Output from this RCA terminal is the digital output data. These signals are not affected by the master level adjustments. We recommend using an RCA cable designed for digital signals (75 ohms). (This can be purchased from an audio/video store.)
rLINE 1, 2, 3, 4 FADER output terminals
Connect these terminals to the Fader input terminals of the
tUSB B terminal
This is connected to a computer to send and receive the USB MIDI, HID and USB audio signals.
The terminal supports USB 2.0 HighSpeed.
Only one mass storage device such as a USB memory or USB hard disk drive can be connected to this terminal.
(* A USB hub is not supported.)
The terminal supports USB 2.0 HighSpeed.
uMIDI output terminal
This is connected to a
iREC OUT terminals
These are the recording output terminals.
oMASTER OUT (UNBALANCED) terminals
•This stereo pair of RCA terminals provides a unbalanced line level output.
•Connect these terminals to the unbalanced analog input terminals on an amplifier or console.
Q0MASTER OUT (BALANCED) connectors
•These XLR type connectors provide a balanced line level output.
•Connect these connectors to the balanced analog input connectors on an amplifier or console.
•Pin layout: 1. GND, 2. Hot, 3. Cold
•Applicable connector: Cannon
TRS plug.
•Pin layout: 1. GND, 2. Hot, 3. Cold
•Applicable connector: Cannon
Q5MIC2 input terminal
Accepts a balanced microphone with 1/4” terminals.
Pin layout (TRS):
Tip: Hot, Ring: Cold, Sleeve: GND
Q6POWER switch
This turns the unit’s power ON (h) or OFF (j).
Fader Start USB Utility Specifications Troubleshooting
5
