INSTALLATION
Continued
Lamps and lava Rock
Before operating fireplace, lamp bulbs must be inspected and lava rock may be added if desired.
1.Lift log bed off hearth base to gain access to lamp fixtures (log bed is attached with contact magnets).
2.Turn on power to light circuit and check that all bulbs are operating. Bulb place- ment front left to right are red, yellow and orange (see Figure 9).
Note: If bulbs need replacing, see Replac- ing Light Bulbs, page 16. Be careful not to tear or damage reflective strips. If they have come loose, ends can be easily reattached or replaced at support brackets. See Replacing Reflective Ribbons, page 21.
3.Center log bed over opening between viewing panel screen and grate.
4.Cover remaining hearth area with 1/4" of lava rock (provided), if desired.
Viewing Panel
Screen
Red
Yellow
Orange
Grate
Log Bed
Figure 9 - Bulb Placement
Features and Operation
This electronic fireplace series features a random flame effect, and a realistic log bed with glistening embers that can be ad- justed for flame speed and light intensity. E36/32LH models have a circulating heater, rated at 1100 Watts. Models E36/32LB and E36/32LBH include a hand detailed, textured,
Access controls by pulling two handle tabs of upper louver until panel releases from magnetic catches and swings down to open position (see Figure 10).
Figure 11, page 8, shows control layout for heater equipped models with main power switch to flame controls and heater power switch (when equipped) to heating unit. This allows independent and efficient operation of both features.
Once main power is turned on, flame speed and brightness may be turned on and adjusted independently.