Accessory Installation, Continued, Optional Brick Liners

Accessory Installation

Continued

Removing Bifold Glass Doors

Bifold doors may be removed for replacing or cleaning.

1.Partially open each door and press up on upper spring clip with a screw driver until outer top pivot pin is free of the clip.

2.Fully fold frame assembly and slide upper edge towards center of firebox opening until the guide pins are free of the frame rail (see Figure 12, page 8).

Installing Series Fixed Glass Doors

1.Hold glass door firmly at both handles and insert top pins into clips located below up- per facial edge of firebox opening. Make sure top pins snap securely into holes on spring clips (see Figure 14).

2.Push up on glass against tension of spring clips. Swing lower door into face until lower pins clear bottom rail and set into locating holes on each end (see Figure 14).

Note: If pins do not align into spring clips, slightly loosen retaining screws on each clip (see Figure 13, page 8). Reinsert panel into each spring clip and align panel into lower locating holes. Remove panel, finish tighten screws and reinsert panel.

Spring Clip

OPTIONAL BRICK LINERS

Installing or Removing Brick Liner Kits Brick liner kits are available for Models E36/32(L)(H) (see Accessories, page 25). These brick panels may be installed anytime after fireplace installation is complete.

Follow these steps to install left and right brick panels:

1.Remove glass doors (if equipped). Follow instructions under Optional Glass Doors, page 8.

2.Remove each retaining screw holding screen rods and pull entire screen and rod assembly out of locating hole on inside top edge of firebox (see Figure 15).

3.Remove log bed from hearth pan and place in a safe area. Log bed is attached with contact magnets only.

4.Remove two screws holding each refrac- tory bracket to firebox. Pull up and lift out of positioning slot at bottom of hearth pan (see Figure 16, page 10).

Note: E36L and E36LH models require removal of additional hearth brackets and face panels which are held in place by 2 screws on hearth pan and one screw at top retainer bracket (see Figure 16, page 10).

Mounting

Holes