Assembly
Estimated assembly time: 45 minutes Tools required:
•#2 Phillips screwdriver
•9/16" and 5/16" Open end wrenches
Hardware packet provided with heater may contain more parts than needed for heater assembly.
Hardware packet contains the following items shown on pages 10 through 13:
Electronic Ignitor (1), Ignitor Wire (1), Ground Wire (1), Valve Knob (1), Propane Tank Reten- tionChain(1),RetentionHook(2),DBatteries(2) and AA Battery (1).
Parts are referenced by designated letter throughout assembly instructions. Hardware packet contains the following (quantity used in parenthesis):
Description |
|
| Part No. |
A 1 1/2" Screw (8) |
|
| |
B 7 mm Washer (8) |
| ||
C 5/8" Screw (9) |
|
| |
D 5 mm Washer (9) |
| ||
E Hex Nut No. 10 (9) |
| ||
F 3/8" Screw (20) |
|
| |
G Hex Nut (20) |
|
| |
H 3/8" Self tapping screw (34) | |||
I 2 1/4" Hex Bolt (2) |
|
| |
J 5/16" Hex Nut (2) |
| ||
B | E |
|
|
A | F | I | J |
C |
G
D | H |
| |
Base Assembly |
1.Turn base upside down. Attach 2 wheels, 2 axles (I) and 2 nuts (J) as shown in Figure 3. Do not overtighten.
2.Attach 4 base feet to base weight with 4 washers (B) and 4 screws (A) as shown in Figure 4. Feet will install over raised areas underneath base weight.
3.Being careful not to scratch paint, lay cabinet base onto back side (use foam packaging block to support rear top of cabinet base). Align holes in bottom edges of cabinet base with holes in base as shown in Figure 4. Attach with 1 screw (C), 1 washer (D) and 1 nut (E) for each of the 9 holes (see Figure 4). Set assembly upright.
4.Attach base to weight with 4 screws (A) and 4 washers (B) as shown in Figure 4.
5.Install chain retainers (“S” hooks) to upper edges of cabinet base as shown in Figure 4.
6.Install electronic ignitor through cabinet wall as shown in Figure 4. Hand tighten.
7.Attach tank door to cabinet with 4 screws
(F) and 4 nuts (G) as shown in Figure 4. Set entire assembly aside.
Wheel
Nut Axle
Base
Figure 3 - Attaching Wheels to Base
Chain | Ignitor | Retainer | |
Retainer | Ring | ||
| |||
|
| Ignitor | |
Cabinet |
| Cap | |
|
| ||
Base |
|
|
Tank
Door
Base
Base
Weight
Base Foot,
Washer and
Hex Bolt
Figure 4 - Cabinet Base Assembly