Manuals / Desa / Household Appliance / Indoor Fireplace

Desa UNVENTED (VENT-FREE) NATURAL GAS FIREPLACE installation manual Installing, Continued

Models: UNVENTED (VENT-FREE) NATURAL GAS FIREPLACE

1 36

Download 36 pages 49.36 Kb

Page 10

ASSEMBLING AND ATTACHING BRASS TRIM

INSTALLING

Continued

10

ASSEMBLING AND ATTACHING BRASS TRIM

Note: The instructions below show assembling and attaching brass trim to fireplace. You cannot attach the brass trim as described below for built-in installation (see page 13).

1.Remove packaging from three pieces of brass trim.

2.Locate four brass screws, two adjusting plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 5.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 5).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 5).

6.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other side.

Top Brass Trim

Side Brass Trim

Set Screws

Adjusting

Plate

Shim

Slot

Mitered Edge

Slot

Figure 5 - Assembling Brass Trim

8.Place the assembled trim onto fireplace cabinet. Attach to fireplace with brass screws included in hardware package (see Figure 6).

Assembled

Brass Trim

Screws

Figure 6 - Attaching Brass Trim to Fireplace

101742

Image 10

Desa UNVENTED (VENT-FREE) NATURAL GAS FIREPLACE Installing, Continued, Assembling And Attaching Brass Trim

Contents

Save this manual for future reference OWNER’S OPERATION AND INSTALLATION MANUALUNVENTED VENT-FREENATURAL GAS FIREPLACE DANGER CONTENTS SAFETY INFORMATIONWARNINGS Safety Information continues on next page INFORMATION SAFETYContinued Figure 1 - Log Base Assembly PRODUCT IDENTIFICATIONFigure 2 - Fireplace Operation LOCAL CODES UNPACKING PRODUCT FEATURESSafety Device Piezo Ignition System AIR FOR COMBUSTION AND VENTILATION PROVIDING ADEQUATE VENTILATION COMBUSTION AIR FORVENTILATION Continued VENTILATION AIR AIR FOR COMBUSTION AND VENTILATIONContinued Ventilation Air from Inside Building NOTICE INSTALLINGContinued Continued INSTALLINGASSEMBLING AND ATTACHING BRASS TRIM Continued INSTALLINGINSTALLATION CLEARANCES CONVENTIONAL FIREPLACE INSTALLATION Continued INSTALLINGheads and putty over Continued INSTALLINGBUILT-INFIREPLACE INSTALLATION Continued Continued INSTALLINGFigure 13 - Attaching Nailing Flange Accessory 39 3/8 27 7/8 35 1/2 55 5/8 Continued INSTALLINGMantel Clearances for Built-InInstallation Continued Installation Items Needed INSTALLINGINSTALLING GAS PIPING TO FIREPLACE LOCATION NOTICE Installation Items Needed INSTALLINGCONNECTING FIREPLACE TO GAS SUPPLY Continued NOTICE G 001WARNINGINSTALLING Continued Continued INSTALLINGPressure Testing Fireplace Gas Connections Continued Figure 21 - Installing Rear Log INSTALLINGINSTALLING LOGS Figure 22 - Installing Front Log Continued INSTALLINGFigure 23 - Installing Crossover Log Continued INSTALLING FOR YOUR SAFETY READ BEFORE LIGHTINGOPERATING FIREPLACE Continued NOTICE OPERATINGFIREPLACE LIGHTING INSTRUCTIONS VARIABLE OUTPUT CONTROL OPERATION MANUAL LIGHTING PROCEDURETO TURN OFF GAS TO APPLIANCE OPERATING FIREPLACE NOTICE INSPECTINGBURNERS PILOT FLAME PATTERN ODS/PILOT AND BURNERS CLEANING AND MAINTENANCE TROUBLE SHOOTINGLOGS Continued TROUBLE- SHOOTINGCleaning and Mainte Continued Cleaning and Mainte TROUBLE SHOOTINGCleaning and Mainte Cleaning and Mainte Continued TROUBLESHOOTING leaks see Checking Gas When gas pressure is too low TECHNICAL SERVICE SERVICE HINTSREPLACEMENT PARTS SPECIFICATIONS When gas quality is bad GMC12U - Unfinished ACCESSORIESCABINET MANTEL GMC11F - Walnut Finished HEARTH BASE GC3333F- Walnut Finished PARTS Log Base AssemblyILLUSTRATED BREAKDOWN PART NUMBER PARTS LISTLog Base Assembly DESCRIPTION PARTS FireplaceILLUSTRATED BREAKDOWN PART NUMBER PARTS LISTFireplace DESCRIPTION LIMITED WARRANTY VENT-FREENATURAL GAS FIREPLACE WARRANTY INFORMATIONKEEP THIS WARRANTY