Desa UNVENTED (VENT-FREE) NATURAL GAS FIREPLACE installation manual Installing, Continued

INSTALLING	8.	Carefully insert fireplace into cabinet mantel. Be careful not to scratch or
		damage hearth base, cabinet mantel, or any laminate trim on hearth base.
Continued		Remove protective material from top of hearth base and from front of fireplace
		(if any). Note: You can secure fireplace to hearth or floor. Open lower louver.
		Locate screw holes in bottom of base. Tighten wood screws through these
		holes and into hearth or floor.
	9.	Check all gas connections for leaks. See Checking Gas Connections, page 18.

Figure 10 - Inserting Fireplace Into Cabinet Mantel

BUILT-IN FIREPLACE INSTALLATION

Built-in installation of this fireplace involves installing fireplace into a framed-in enclosure. This makes the front of fireplace flush with wall. If installing a mantel above the fireplace, but you must follow the clearances shown in Figure 15, page 15. Follow the instructions below to install the fireplace in this manner.

IMPORTANT: For built-in installation, nailing flange accessory G3004 is required. Do not attach brass trim around fireplace for built-in installation.

Height		Front Width		Depth
Actual	Framing	Actual	Framing	Actual	Framing
32 3/8"	33"	34 5/16"	35 1/2"	16 11/16"	17 3/4"

1.Frame in rough opening. Use dimensions shown in Figure 11 for the rough opening.

17 3/4"

33"

Continued

35 1/2"

Figure 11 - Rough Opening for Installing in Wall 13

101742