Desa VDCFRNA, VDCFRPA Installation, CAUTION Verify proper op- eration after servicing, Continued

INSTALLATION

Continued

2.Remove 4 screws from upper louver (see Figure 11, page 12). Save these screws.

3.Pull upper louver straight out from the cabinet. Be careful not to scratch the paint. Set louver aside.

4.Open lower louver door by swinging door down (see Figure 11, page 12).

Installing Blower Accessory

CAUTION: Label all wires prior to disconnection when ser- vicingcontrols.Wiringerrorscan cause improper and dangerous operation.

CAUTION: Verify proper op- eration after servicing.

Note: If you are using a mantel with your fireplace, use the following instructions. If your fireplace is built-in, see For Built-In Installation, page 15.

1.Install snap bushings found in blower kit into hole in left side of outer casing and into one of the holes in rear of remote/blower bracket.

2.Make sure the wire harness is firmly connected to the terminals on the blower bracket assembly.

3.Note the wire locations on back of AUTO/ OFF/ON switch. The terminals on back of switch are numbered 1, 2 and 3. Carefully remove red wire from terminal 3 and blue wire from terminal 1. Black wire can remain on middle terminal 2 (see Figure 14).

Blower	Wiring Routing
Bracket	Wire Hole in Baffle	Blower
Assembly	Harness
		Mounting
Screw
		Holes

4.Carefully disconnect green and white wires at their insulated connectors (see Figure 15).

5.In top of the fireplace cabinet, locate the four mounting holes on the outer casing. Align these four holes with those on the blower bracket assembly. Attach blower bracket as- sembly to the outer casing with 4 #10 screws provided (see Figure 14).

6.Route the wire harness through the hole in left side of baffle and between firebox wrapper and outer casing.

7.Insert the 4 wire harnesses from behind the remote/blower bracket through hole in rear of bracket with bushing and through the left rectan- gular hole to front of fireplace (see Figure 14).

8.Reconnect red wire to switch position 3. Reconnect blue wire to switch position 1. Reconnect green and white wires.

9.Install the switch plate on the remote/blower bracket with 2 #10 screws provided (see Figure 16). Route power cord out of the cabinet by insert- ing it through the bushing on the outer casing (see Figure 14). Plug fan kit into 120-Volt grounded power supply and test operation. Note: When switch is in the AUTO position, the fan will start after the fireplace has run for a few moments. The fan will continue to run for several moments after the fireplace has been turned off. When switch is in the ON position, the fan will run until turned to OFF.

10.Reinstall upper louver beginning with bottom screws (see Figure 11, page 12). Close lower louver door.

Fan Switch (Auto/Off/On)

1Auto

	Off	2
		3	Blue	Thermostat
		On		Switch
				(N.O.)
				Blue
110/115		Red		Blower
V.A.C.
	Black			Motor
				Red
	White			White
	Green			Green

Switch	Power
	Cord
3
2
1
Switch
Plate	Remote/
Wire
	Blower

Harness Bracket

Lower Louver Door

Figure 15 - Wiring Diagram For Blower

Accessory Standard Installation

Remote/

Blower

Bracket

Switch

Plate

Screw

Figure 14 - Installing Blower Bracket Assembly (Remote-Ready Unit Shown)

Figure 16 - Installing Switch Plate to

Remote/Blower Bracket

14 www.desatech.com 113133-01B