OPERATING FIREPLACE
Continued
5.Press in and turn control knob counter-
clockwise 
to the PILOT position. Press in control knob for five (5) seconds (see Figure 39).
Note: You may be running this fireplace for the first time after hooking up to gas sup- ply. If so, the control knob may need to be pressed in for 30 seconds or more. This will allow air to bleed from the gas system.
6.With control knob pressed in, press and release ignitor button. This will light pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure.
7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4 through 8.
8.Slightly push in and turn control knob coun-
terclockwise 
to the ON position.
9.Set flame adjustment knob to any level between HI and LO.
CAUTION: Do not try to ad- just heating levels by using the equipment shutoff valve.
Piezo | Flame | Control | |
Ignitor | |||
Adjustment | Knob | ||
Button | |||
Knob |
| ||
|
|
Figure 39 - Control Knob and Ignitor
Button Location (Shown as Supplied
- No Control Options)
Pilot | Ignitor | |
Burner | ||
Electrode | ||
|
Figure 40 - Propane/LP Gas Pilot | ||
Pilot Burner | Ignitor | |
Electrode | ||
| ||
Figure 41 - Natural Gas Pilot
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Fireplace
1.Turn control knob clockwise 
to the OFF position.
2.If Using Optional
Shutting Off Burners Only (pilot stays lit) You may shut off the burners and keep the pilot lit by doing one of the following:
1.Turn control knob clockwise 
to the PILOT position.
2.If Using Optional
WARNING: Make sure re- mote sensor selector switch is in the OFF position when you are away from home for long periods of time.
MANUAL LIGHTING
PROCEDURE
1.Follow steps 1 through 5 under Lighting Instructions, starting on page 23.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 8 and 9 under Lighting Instructions.
24 | www.desatech.com |
