CLEANING AND

MAINTENANCE

Continued

We also recommend that you keep the burner tube and pilot assembly clean and free of dust and dirt. To clean these parts we recommend using compressed air no greater than 30 PSI. Your local computer store, hardware store or home center may carry compressed air in a can. You can use a vacuum cleaner in the blow position. If using com- pressed air in a can, please follow the directions on the can. If you donʼt follow directions on the can, you could damage the pilot assembly.

1.Shut off the unit, including the pilot. Allow the unit to cool for at least thirty minutes.

2.Inspect burner, pilot and primary air inlet holes on injector holder for dust and dirt (see Figure 50).

3.Blow air through the ports/slots and holes in the burner.

4.Check the injector holder located at the end of the burner tube again. Remove any large particles of dust, dirt, lint or pet hair with a soft cloth or vacuum cleaner nozzle.

5.Blow air into the primary air holes on the injector holder.

6.In case any large clumps of dust have now been pushed into the burner repeat steps 3 and 4.

Clean the pilot assembly also. A yellow tip on the pilot flame indicates dust and dirt in the pilot as- sembly. There is a small pilot air inlet hole about two inches from where the pilot flame comes out of the pilot assembly (see Figures 51 or 52 depending on model). With the unit off, lightly blow air through the air inlet hole. You may blow through a drinking straw if compressed air is not available.

LOG SET

If you remove one-piece log set for cleaning, refer to Installing Log Set and Screen, page 21, for placement instructions.

Replace log set if broken or chipped (dime-sized or larger).

CABINET

Air Passageways

• Use a vacuum cleaner or pressurized air to clean.

Exterior

Use a soft cloth dampened with a mild soap and water mixture. Wipe the cabinet to remove dust.

Pilot Air Inlet Hole

Pilot Assembly

Figure 51 - Pilot Inlet Air Hole (Propane/LP Gas)

Pilot Air Inlet Hole

Pilot Assembly

Figure 52 - Pilot Inlet Air Hole (Natural Gas)

Injector Holder

Burner

Tube

Primary Air

Inlet Holes

Figure 50 - Injector Holder On Outlet

Burner Tube

 

WIRING DIAGRAM

 

(Remote-Ready Models Only)

 

Auto

 

Black

 

 

 

 

Off

Switch

Red

 

On

 

 

 

 

 

 

 

TPTH

TH

 

 

Gas Control

 

 

TPTH

TP

 

 

Red

 

Thermopile

White

 

 

 

 

28

www.desatech.com

113133-01B

Page 28
Image 28
Desa VDCFTPA, VDCFRPA, VDCFRNA installation manual Log Set, Cabinet, Air Passageways, Exterior, Remote-Ready Models Only