INSTALLATION
Continued
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
Remote-Ready Models Only
([C]GHRCB Series & [C]GHRCTB
Series)
Installing Receiver
1.Disconnect wires from the control valve (see Figure 26) .
2.Locate the battery clip mounted on the back of the receiver (see Figure 27).
3.Slide
4.Attach the terminal wires to the battery (see Figure 27).
5.Connect wires from remote receiver to control valve as shown in Figure 28.
6.Install remote receiver unit onto remote/ blower bracket using screws provided (see Figure 28).
Figure 26 - Disconnecting Wires From
Control Valve
Receiver
Installing 9-Volt Battery in Hand-Held Remote Control Unit
1.Remove battery cover on back of remote control unit.
2.Attach terminal wires to the battery (not in- cluded). Place battery into the battery housing.
3.Replace battery cover onto remote control unit.
Terminal | Battery Cover | Remote |
| |
|
|
| ||
|
| Control | Unit | |
Wires |
|
| ||
|
|
|
| |
|
|
|
| |
Battery |
|
|
|
|
|
|
| Battery |
|
|
|
| Housing |
|
Figure 29 - Installing Battery in Hand- | ||||
Held Remote Control Unit |
| |||
(GHRCB and CGHRCB Series) |
| |||
Terminal Wires | Remote Control | Unit | ||
|
|
| ||
|
|
|
| |
Battery |
|
|
|
|
|
|
| Battery | |
Battery |
|
| Cover | |
|
|
|
| |
Housing |
|
|
| |
Figure 30 - Installing Battery in Hand- | ||||
Held Remote Control Unit |
| |||
(GHRCTB and CGHRCTB Series) |
| |||
| Terminal |
Battery | Wires |
| Battery Clip |
Figure 27 - Attaching Battery to Receiver
White Wire to
TH Terminal on
Control Valve
Remote
Receiver
Red Wire to
TPTH Terminal on
Control Valve
Figure 28 - Installing Remote Receiver
OPTIONAL WALL MOUNTED THERMOSTAT - GWMT1
WARNING: Read and fol- low installation instructions. Installation should be done by a qualified installer familiar with
WARNING: Do not connect this thermostat to any electrical source! Electrical shock and/or fire hazard will occur.
1.Remove jumper wire from control valve (see Figure 26).
www.desatech.com | 19 |
