OPERATING FIREPLACE
INSERT
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a quali- fied service technician to inspect the appli- ance and to replace any part of the control system and any gas control which has been under water.
LIGHTING
INSTRUCTIONS
WARNING: You must oper- ate this heater with the fireplace insert screen in place. Make sure fireplace insert screen is in- stalled before running fireplace insert.
NOTICE: During initial operation of new fireplace insert, burning logs will give off a
1.STOP! Read the safety information column 1.
2.Make sure equipment shutoff valve is fully open.
3.Set switch to OFF position.
WARNING: Burners will come on automatically within one minute when the remote se- lector switch is in the ON posi- tion after the pilot is lit.
4.Press in and turn control knob clockwise to the OFF position.
5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information in column 1. If you don’t smell gas, go to the next step.
6.Press in and turn control knob counter-
clockwise to the PILOT position. Press in control knob for five (5) seconds (see Figure 32).
Note: You may be running this heater for the first time after hooking up to gas sup- ply. If so, the control knob may need to be pressed in for 30 seconds or more. This will allow air to bleed from the gas system.
Ignitor Button
IH |
|
|
|
|
| O |
|
|
| F | AUTO |
N |
| F | |
O |
| P | OFF |
LO | I | ||
TOL |
| ||
|
|
| ON |
Flame | Control | Selector Switch |
Adjustment | Knob |
|
Knob |
|
|
Figure 32 - Control Knob and Ignitor
Button Location (Shown as Supplied, No
Control Options)
www.desatech.com | 19 |