INSTALLATION
Continued
OPTIONAL WIRELESS
Installing Remote Receiver Unit
1.Disconnect switch wires from the control valve.
2.Remove screws attaching switch plate.
3.Remove switch plate (see Figure 26). Discard after removing.
4.Install remote receiver unit onto gas log heater base using mounting clips.
5.Push clips firmly into place (see Figure 27).
6.Connect wires as shown in Figure 28.
Remote Switch | Ignitor | |
Bracket | ||
|
Screw
Switch
Plate
Wires
Figure 26 - Switch Plate and Wiring
Harness
Mounting
Clips
Remote
Receiver
Figure 27 - Installing Remote Receiver
White Wire
From
Receiver
Valve
Red Wire
From Receiver
Figure 28 - Connecting Wires
INSTALLING 9-VOLT BATTERIES
Two
Remote
Receiver
| Battery | Terminal |
Clip | Wires |
Figure 29 - Installing Battery in Remote
Receiver
Installing 9-Volt Battery (Not Included) in Receiver
1.Locate back of receiver under front burner of heater.
2.Locate the battery clip mounted on the back of the receiver.
3.Slide a
4.Attach the terminal wires to the battery.
Battery Cover | Remote | |
Control Unit | ||
| ||
Terminal |
| |
Wires |
| |
| Battery | |
Housing | ||
|
Figure 30 - Installing Battery in Hand-Held
Remote Control Unit (GHRCB Series)
Terminal
Battery
Remote
Control
Battery Unit
Cover
Figure 31 - Installing Battery in
18 | www.desatech.com |