OPERATING FIREPLACE
INSERT
Continued
Auto Shutoff Feature
1.If the average room temperature exceeds 82 degrees Fahrenheit (28 degrees Centi- grade), the
2.The receiver continuously receives signals from the
Key Pad Lock Feature
This feature allows the user to lock/unlock the keypad on the
OPTIONAL BLOWER
OPERATION
Locate the blower switch by opening lower lou- ver on fireplace insert. Blower switch is located at lower left inside louver door.
This
Note: Your gas logs and thermostat blower will not turn on and off at the same time. The fire- place insert may run for several minutes be- fore the blower turns on. After the heater modu- lates to the pilot position, the blower will con- tinue to run. The blower will shut off after the firebox temperature decreases.
Note: It is safe to operate fireplace insert with blower turned off. However, the blower helps distribute heated air from the fireplace insert.
INSPECTING BURNERS
Check pilot flame pattern and burner flame pat- terns often.
PILOT FLAME PATTERN
Figure 37 shows a correct pilot flame pattern. Fig- ure 38 shows an incorrect pilot flame pattern. The incorrect pilot flame is not properly heating the thermocouple. When the thermocouple cools, the heater will shut down.
If pilot flame pattern is incorrect, as shown in Fig- ure 38
•turn heater off (see To Turn Off Gas to Appli- ance, page 20)
•see Troubleshooting, page 25
Note: The pilot flame on natural gas units will have a slight curve, but flame should be blue and have no yellow or orange color.
Pilot Burner Thermocouple Pilot Burner
Natural Gas | Propane/LP Gas |
Figure 37 - Correct Pilot Flame Pattern
Pilot Burner
Pilot Burner | Thermocouple |
|
Natural Gas | Propane/LP Gas |
Figure 38 - Incorrect Pilot Flame Pattern
22 | www.desatech.com |