AT&T ATTTL92273 Battery installation and charging, Battery indicators Battery status Action

Getting started

Battery installation and charging

Once you have installed the battery, the screen indicates the battery status (see table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 11 hours of continuous charging. See the table on page 127 for battery operating times.

If the screen is blank, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. When the battery is low, the handset shows Low battery and a flashing . If you are on a call in low battery mode, the handset beeps every minute.

The following table summarizes the battery charge indicators and actions to take.

Battery indicators		Battery status	Action
The screen is blank or		The battery has no or	Charge without interruption (at least 30
shows Place in charger		very little charge. The	minutes).
and	flashes.	handset cannot be used.
The screen shows		Battery has enough	Charge without interruption (at least 30
Low battery and		charge to be used for a	minutes).
flashes.		short time.
The screen shows		Battery is charged.	To keep the battery charged, place it in the
HANDSET X.			telephone base or charger when not in use.