AT&T ATTTL92273 user manual Select

Adding

Headset A

1

Headset A

is added

and connected

to base.

Bluetooth

Bluetooth setup

6.Set your headset to discoverable mode (refer to the user’s manual of your headset), then press NEXT. The screen displays Searching for Bluetooth headsets...

•All devices that are connected to the telephone base are temporarily disconnected.

7. When the screen displays the found devices, press CID or DIR to highlight your headset if necessary, then press

SELECT.

•Enter the PIN of your headset if required. The PIN for most Bluetooth devices is 0000 (refer to the user’s manual of your headset). Press NEXT to continue.

The screen displays Adding Headset A when the base is connecting to your headset.

When a device is successfully connected, the handset displays Headset A is added and connected to base and the corresponding status icon (2) displays on the handset. You hear a confirmation tone. The CELL 2/HEADSET light on the telephone base turns on.

Searching for

Bluetooth

headsets...

FOUND DEVICES

Headset A

Headset B

BACK SELECT

If you have trouble pairing your headset, it may not be

compatible with your TL92273/TL92373/TL92473. Check

the Bluetooth compatibility list at www.telephones.att.com/bluetooth.

NOTES:

•The pairing process may take up to one minute. If the pairing process fails, try again.

•If you put the handset back in the telephone base or charger while pairing, the process discontinues and the handset returns to idle mode.

•If a device fails to connect, the handset displays Headset A is added, and then displays Please use headset to connect to base.

•When a connected headset is charging, it may disconnect from the telephone base and the corresponding light on the telephone base (CELL 2/HEADSET) turns off. For some headset models, you may need to turn on the headset and reconnect it to the telephone base again.

19