AT&T ATTTL92273 Auto connection, Bluetooth connection from idle mode, Device list and connection

Bluetooth

Bluetooth setup

Auto connection

When an active device moves within Bluetooth range of the telephone base, or is turned on within range, the telephone base tries to connect to the device. When the device moves out of range, it is disconnected. Your device might make a connect or disconnect sound.

A connected device could also be disconnected by:

•Turning off the Bluetooth device.

•Turning off the Bluetooth feature of the device.

•Disconnecting through the telephone base Device list. If you disconnect through the Device list, the telephone base will not attempt to reconnect until your device is moved out of range and then moves back in

range again.

Bluetooth connection from idle mode

When you have active devices that are not connected, CONNECT appears on the idle handset. Press CONNECT to start connecting an active device. When there are two active devices, the handset will prompt you to choose one before connection.

Device list and connection

Up to 4 devices can be paired to the telephone base. All paired devices are shown on the device list. To use a paired device, it must be connected and in an active slot (D1: or D2:) on the device list. Both active devices can be on a call at a time.

Once you have paired a device with the telephone base, you do not need to repeat the pairing procedure again unless you delete the device from the device list.

NOTE: When connecting a Bluetooth device to the device list, all connected devices will be temporarily disconnected until the procedure is complete. It may take up to 2 minutes to reconnect.

20