AT&T ATTTL92273 user manual Telephone base and charger installation, Telephone base installation

Getting started

Telephone base and charger installation

Install the telephone base and charger as shown below.

The telephone base is ready for tabletop use. If you want to change to wall mounting, see Installation options on page 9 for details.

Telephone base installation

Plug one end of the telephone line cord into a

telephone jack or a DSL filter.

If you have DSL high-speed Internet service, a DSL filter (not included) is required.

The DSL filter must be plugged into the telephone wall jack.

Route the telephone line cord through this slot.

Plug the large end of the telephone base power adapter into a power outlet not controlled by a wall switch.

Raise the antenna.		Route the power adapter
Plug the other end of the		cord through this slot.
telephone line cord into the
telephone jack on the back
of the telephone base.	Plug the small end of the telephone base power adapter into
	the power adapter jack on the back of the telephone base.

Charger installation

Plug the power adapter into an electrical outlet not controlled by a wall switch.

IMPORTANT INFORMATION:

•Use only the power adapter(s) provided with this product. To obtain a replacement, visit our website at

www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial

1 (866) 288-4268.

• The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.