Answering system

Answering system settings

Number of rings

You can set the answering system to answer an incoming call after two, three, four, five, or six rings. You can also select toll saver, which is explained below. By default, the answering system answers an incoming call after four rings.

To set the number of rings:

1.

Press

MENU

in idle mode.

2.

Press

CID or

DIR to highlight Answering sys, then press

 

 

.

 

 

SELECT

 

3.

Press

CID or

DIR to highlight Ans sys setup, then press

 

 

.

 

 

SELECT

 

4.

Press

CID or

DIR to highlight # of rings, then press

 

SELECT

.

 

5.

Press

CID or

DIR to choose from 6, 5, 4, 3, 2 or

 

Toll saver.

 

ANS SYS SETUP Call screening

#of rings Remote code

BACK SELECT

# OF RINGS

6

5 4

BACK SELECT

Toll saver - the answering system answers a call after

two rings when you have new messages, or after four rings when there are no new messages. This feature allows you to check for new messages and avoid paying long distance charges when calling from out of your local area.

6.Press SELECT to confirm. You hear a confirmation tone.

NOTE: If you set the number of rings for the answering system as 2 or 3 rings, the caller ID announce feature may not have enough time to announce the caller’s

full information.

81

Page 87
Image 87
AT&T ATTTL92273 Number of rings, To set the number of rings, DIR to highlight # of rings, then press, Toll saver