22
FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL36DA(SA) and BL36DHA(SA)
Wall Switch Installation
Optional Remote Control Installation
FIREPLACE INSTALLATION
Continued
2.Rest log #2 (large front log) on the pins on the front part of the grate (see Figure 41).
3.Place log #3 (crossover log) onto the rear and front logs. Make sure it is seated properly on the smooth surface on the front log and on the pin on the back log as shown in Figure 42.
4.Place log #4 (right log) on the pin on the right side of front log as shown in Figure 43.
5.Place log #5 (base log) onto the front left part of the grate making sure the notches fit over the prongs of the grate). See Figure 44.
6.Place log #6 (left log) onto two pins on the left side of back and front log. See Figure 44.
7.Place lava rock along sides and front of firebox bottom in areas that are visible only. It is not necessary to use all of the lava rock provided.
8.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the ex- posed section of the front burner and along the space between the burner and grate prongs (see Figure 45). This will create the glowing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
9.Close glass door, lock door latches, replace screen and close louvers (see steps 5 and 7 of Removing/Replacing Glass Door, page 20).
4 
2
Figure 43 - Installing Log No. 4
6
5
Figure 41 - Installing Log No. 2
3
Figure 44 - Installing Logs No. 5 and No. 6
Figure 42 - Installing Log No. 3 | Ember Material |
|
Figure 45 - Placing Ember Material on Burner
www.desatech.com |
