SAFETY INFORMATION PRODUCT IDENTIFICATION LOCAL CODES
3
SAFETY INFORMATION
Continued
PRODUCT IDENTIFICATION
5. | This fireplace reaches high temperatures. Keep children and |
| adults away from hot surfaces to avoid burns or clothing igni- |
| tion. Fireplace will remain hot for a time after shutdown. Allow |
| surfaces to cool before touching. |
6. | Carefully supervise young children when they are in the room |
| with fireplace. |
7. | Do not modify this fireplace under any circumstances. Any |
| parts removed for servicing must be replaced prior to operating |
| fireplace. |
8. | Turn fireplace off and let cool before servicing, installing or |
| repairing. Only a qualified service person should install, service |
| or repair this fireplace. Have fireplace inspected annually by a |
| qualified service person. |
9. | You must keep control compartments, burners and circulating |
| air passages clean. More frequent cleaning may be needed due |
| to excessive lint and dust from carpeting, bedding material, etc. |
| Turn off the gas valve and pilot light before cleaning fireplace. |
10. | Have venting system inspected annually by a qualified service |
Upper Louver
Panel
Nailing
Flange
Glass
Door
Assembly
Lower
Louver
Panel
Flue Collar
Log 
Set
Lava |
Rock |
| person. If needed, have venting system cleaned or repaired. See |
| Cleaning and Maintenance, page 25. |
11. Keep the area around your fireplace clear of combustible ma- | |
| terials, gasoline and other flammable vapor and liquids. Do |
| not run fireplace where these are used or stored. Do not place |
| items such as clothing or decorations on or around fireplace. |
12. | Do not use this fireplace to cook food or burn paper or other |
| objects. |
13. | Do not use any solid fuels (wood, coal, paper, cardboard, etc.) |
| in this fireplace. Use only the gas type indicated on fireplace |
| nameplate. |
14. | This appliance, when installed, must be electrically grounded |
| in accordance with local codes or, in the absence of local |
| codes, with the National Electrical Code, ANSI/NFPA 70 or |
| the Canadian Electrical Code, CSA C22.1. |
15. | Do not use fireplace if any part has been exposed to or under |
| water. Immediately call a qualified service person to arrange |
| for replacement of the unit. |
16. | Do not operate fireplace if any log is broken. |
17. | Do not use a blower insert, heat exchanger insert or other ac- |
| cessory not approved for use with this fireplace. |
18. | Do not operate fireplace with glass door removed, cracked or |
| broken. |
19. | Provide adequate clearances around air openings. |
Electronic | Glowing |
Control Valve | Embers |
Burner |
|
Assembly | Switch Bracket for |
| |
| Optional Remote and |
| Blower |
Figure 1 - Direct-Vent Fireplace with Electronic Ignition
LOCAL CODES
Install and use fireplace with care. Follow all local codes. In the absence to local codes, use the current National Fuel Gas Code ANSI Z223.1/NFPA 54* (USA) or the current
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
www.desatech.com |
