23
FIREPLACE INSTALLATION
Continued
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace.
OPTIONAL REMOTE CONTROL
INSTALLATION (Model WRC)
Note: If using optional wireless
1.Open lower louver panel.
2.The WRC model receiver does not require a battery. The receiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 46).
3.Activate the remote handset battery by removing the insulating tab on the back of the handset (see Figure 47). The battery is included
4.Once the battery is activated the unit is ready to use.
5.Close lower louver panel.
Fireplace
Receptacle
Remote Control
Receiver
Extension Cord | Ignition | |
Module Plug | ||
|
Figure 46 - Installing the WRC Remote Receiver
Battery Cover
12 Volt Battery
Back of
HandsetPull to Remove
Insulation Tab
Figure 47 - Installing Battery into Back of Handset
WIRING DIAGRAM |
|
|
| |
| PILOT |
|
|
|
IGNITOR LEAD |
|
|
|
|
ORANGE |
|
|
|
|
|
| SYNETEKCONTROLS IS1070B | BLUE | 120VAC |
| E2 | 24VAC | ||
| E12 |
| TRANSFORMER |
|
|
|
| WHITE |
|
EV1 | E8 |
|
|
|
|
|
|
| |
| E6 |
|
|
|
| E4 |
|
|
|
| E3 |
|
|
|
|
| INC | BLACK |
|
|
|
|
| |
|
|
| GROUND |
|
EV2 |
|
| RED |
|
|
|
|
| |
| GREEN |
|
|
|
OPERATING FIREPLACE
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch.
•Do not use any phone in your building.
•Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
www.desatech.com |
