Desa (V)T36NA SERIES INSTALLING OPTIONAL WALL MOUNT SWITCH - GWMS2, Fireplace Installation

FIREPLACE INSTALLATION

Checking Gas Connections (Cont.) Installing Optional Wall Mount Switch - GWMS2 Installing Optional Wireless Hand-Held Remote Control - GHRC and GHRCT(A) Series

21

FIREPLACE INSTALLATION

Continued

Pressure Testing Fireplace Gas Connections

1.	Open equipment shutoff valve (see Figure 33, page 20).
2.	Open propane/LP supply tank valve for propane/LP fireplace
	or main gas valve located on or near gas meter for natural gas
	fireplace.
3.	Make sure control knob of fireplace is in the OFF position.
4.	Check all joints from equipment shutoff valve to gas valve (see

3.Locate the battery clip mounted on the back of the receiver. Slide a 9-volt alkaline battery (not included) through the clip (see Figure 37).

4.Attach the terminal wires to the battery.

5.Connect wires from receiver to TH and TPTH to control valve (see Figure 38).

6.Replace the switch bracket.

	Figure 34 for propane/LP or Figure 35 for natural gas, page 20).
	Apply noncorrosive leak detection fluid to all joints. Bubbles
	forming show a leak. Correct all leaks at once.
5.	Light fireplace (see Operating Fireplace, page 25). Check all
	other internal joints for leaks.
6.	Turn off fireplace (see To Turn Off Gas to Appliance, page 25).

INSTALLING OPTIONAL WALL MOUNT SWITCH - GWMS2

1. Connect one terminal of 25 ft. wire for the wall switch to the

Receiver

9-Volt Alkaline Battery

Terminal

Wires

Battery Clip

Figure 37 - Attaching Alkaline Battery to Receiver

To Optional

Remote

Accessory

Figure 38 - Connecting Remote Accessory to Control Valve

	TPTH terminal on the valve. Connect remaining wire terminal
	to the TH terminal on the valve. Make sure that the wire termi-
	nals are in the positions on the unit as pictured in Figure 36. If
	wires are not connected as shown the switch will not work.
2.	Route the 25 ft. wire through openings provided on the sides of
	the burner system to a convenient location to mount your switch.
3.	Connect one bare wire end to each of the terminals of the
	GWMS2 wall switch.
4.	Install the wall switch and cover in the wall.

To Wall Switch

Accessory

Installing 9-Volt Alkaline Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to a 9-volt alkaline battery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

	Battery Cover	Remote
Terminal
		Control Unit
Wires

9-Volt Alkaline Battery

Battery

Housing

Figure 36 - Connecting Wall Swith to Control Valve

INSTALLING OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL - (C)GHRC AND (C)GHRCTA SERIES

NOTICE: Use only alkaline batteries (not included).

Figure 39 - Installing Alkaline Battery in Hand-Held Remote Control Unit ([C]GHRC)

	Terminal
9-Volt	Wires
Battery

Installing Remote Receiver

1.Open bottom louver and locate the switch bracket on the left.

2.Unscrew the switch bracket. Lean bracket forward so you are able to access the back of the remote receiver.

Battery Cover

Remote

Control

Unit

Figure 40 - Installing Battery in Hand-Held Remote Control Unit

([C]GHRCTA Series)

For morevisit www..com

111250-01C