FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL36D(S) and BL36DH(S) Installing Logs, Lava Rock and Glowing Embers
23
FIREPLACE INSTALLATION
Continued
INSTALLING OPTIONAL BRICK LINER MODELS BL36DA(SA) AND BL36DHA(SA)
WARNING: If fireplace has been running, turn off and unplug fireplace. Let cool before installing brick liner.
This brick liner kit is optional. You may purchase brick liner from your local retailer or see Accessories, page 37.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Exces- sive force will break brick panels.
Left Side Brick Panel
1.Remove top and bottom louvers to allow access to door latches.
2.Unlock door latches and open glass door. See steps 1 and 2 of Removing/Replacing Glass Door.
3.If installing brick liner in new fireplace, go to step 4 on page 23. If installing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.
4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.
5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 43).
6.Install left side brick panel by sliding it between the grate and the side of the firebox (see Figure 44).
7.Install the right brick panel using the same method described
8.Replace deflector shield using screws removed in step 4.
9.Follow instructions on page 24 to install logs, lava rock, and ember material.
10.Close glass door, lock latches on top and bottom of door and replace screen (see steps 5 and 6 of Removing/Replacing Glass Door, page 22).
11.Close top and bottom louvers.
Figure 44 - Installing Left Side Brick Panel
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See steps 1 and 2 of Removing/Replacing Glass Door, page 22. Install logs according to instructions for fireplace model numbers.
1.Place log #1 (rear log) on top of grate. Make sure the notches in the bottom of the log fit over the grate (see Figure 45).
2.Rest log #2 (large front log) on the pins on the front part of the grate (see Figure 46, page 24).
Rear Brick Panel
Figure 45 - Installing Log No. 1
Figure 43 - Installing Rear Brick Panel
For more
visit www.
.com
