Desa VTP22R WARNING Never install the heater, in a bedroom or bathroom, in a recreational vehicle

INSTALLATION

Continued

WARNING: Never install the heater

•in a bedroom or bathroom

•in a recreational vehicle

•where curtains, furniture, clothing or other flammable objects are less than 36 inches (91.4 cm) from the front or top of the heater or less than 10" (25.4 cm) from sides of heater

•as a fireplace insert

•in high traffic areas

•in windy or drafty areas

CAUTION: If you install the heater in a home garage

•heater pilot and burner must be at least 18 inches (45.7 cm) above floor

•locate heater where moving vehicle will not hit it

CAUTION:Thisheatercreates warmaircurrents.Thesecurrents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operatingheaterwhereimpurities (such as, but not limited to, to- bacco smoke, aromatic candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may discolor walls or cause odors.

IMPORTANT: Vent-free heaters add moisture to the air. Although this is beneficial, installing heater in rooms without enough ventilation air may cause mildew to form from too much moisture. See Air for Combustion and Ventilation, page 5. If high hu- midity is experienced, a dehumidifier may be used to help lower the water vapor content in the air.

For convenience and efficiency, install heater

•where there is easy access for operation, inspec- tion and service

•in coldest part of room

An optional fan kit is available from your dealer. See Accessory, page 22. If planning to use fan, locate heater near an electrical outlet.

INSTALLING REMOTE CONTROL RECEIVER

Remote control receiver must be installed to oper- ate the remote control.

1.Locate receiver bracket, two packages of AA batteries, remote receiver and screws in hardware bag included with your heater.

2.Remove battery cover on receiver and install batteries as shown in Figure 5. Replace battery cover.

3.Insert wire connector and wire through bush- ing on the back of heater (see Figure 6).

4.Lay heater onto its side. Insert wire connector into valve at location shown in Figure 7 page 9. Feed extra wire from receiver into heater base. Place heater back in upright position.

5.Attach bracket around receiver with screws as shown in Figure 6.

Receiver

AA Batteries

Battery Cover

Figure 5 - Installing Batteries in Receiver

Receiver

Receiver	Wire	Bushing
	Connector
Bracket
Figure 6 - Installing Remote Receiver

8 www.desatech.com 113261-01C