SERVICE INSTRUCTIONS
Motor Pulley and Flywheel Alignment
1.Remove outer beltguard - To remove, loosen and remove beltguard screws located at top of beltguard. Insert a flat bladed screwdriver and pry beltguard apart.
2.Place a straight edge along the outside face of the compressor flywheel to check alignment of
3.If the belt grooves aren't aligned, continue with step 4 of this procedure. If the belt grooves are aligned, continue with step 6 of this procedure.
4.Loosen pulley set screw and adjust pulley until it is in proper alignment.
5.Tighten pulley set screw to
6.Reinstall belt guard.
Additional Service
Disassembly or service of the air compressor beyond what is covered in this manual is not recommended.
If additional service is required, contact your nearest Authorized Warranty Service Center.
STORAGE OF COMPRESSOR OUTFIT
1.Review the Maintenance section on the preceding pages and perform scheduled maintenance as necessary. Drain the water from the air tank.
2.Turn compressor off and disconnect or lock out power source.
4.Protect the electrical cord and/or air hose from damage (such as being stepped on or run over).
5.Store the compressor in a clean and dry location.
3. Remove any air tool or accessory.
