DeWalt 1 appendix Click Cancel to stop the setup

Chapter 2 Setting Up BBSM Hotspot

Running the Setup Wizard

–After the question asking if you want to change your IP addresses, click No to ignore the connectivity issues and continue with the setup. A warning message pops up to tell you that you must resolve the IP address issue for BBSM Hotspot to work properly. (See Figure 2-9.) You are then taken to the Enter Network Device Configuration Parameters window.

(See Figure 2-10.)

–Click Cancel to stop the setup.

Figure 2-8 Test Failure Window

Figure 2-9 You Must Resolve This Issue Dialog Box

Step 11 Click Next. The Enter Network Device Configuration Parameters window appears. (See Figure 2-10.)

Cisco BBSM Hotspot 1.0 User Guide

78-15293-01 2-11