UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE CURRENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS CONTAINED IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED TO ILLUSTRATE TECHNIQUE ONLY.
REMOVING SHIPPING CRATE
Your new 12″ Jointer is shipped complete in one wooden shipping crate. Remove the crate from around the machine leaving the bottom of the machine fastened to the shipping skid at this time. Remove the fence assembly, dust hood and all loose items from the shipping crate. Figure 4 illustrates all the loose items supplied with your machine.
1
2
53
4
6
8
7
|
|
| Fig. 4 |
|
|
1 | - Dust Hood | 6 | - Push Blocks (2) | 10 | - 4mm |
2 | - 8mm Hex wrench | 7 | - |
| (not shown) |
3 | - 12 and 14mm open end wrench |
| Socket Head Screws (2) | 11 | - 3mm and 10mm Hex wrench |
4 | - 10 and 12mm open end wrench | 8 | - Flat Washers (2) |
| (not shown) |
5 | - 5/8″ long Button Head | 9 | - Fence Assembly | 12 | - 17mm and 19mm Open end |
| Screws (7) |
|
|
| wrench (not shown) |
8
