DeWalt DW745 instruction manual Dust Collection, Accessories Storage, Lubrication

WARNING: Use featherboards for all non-thru-sawing operations where the blade guard assembly, anti-kickback assembly and riving knife cannot be used. Always replace the blade guard assembly, anti-kickback assembly and riving knife when the non-thru- sawing operation is complete. Make sure the featherboard presses only on the portion of the workpiece in front of the blade.

FIG. 42

Dust Collection

Your table saw is equipped with a dust shroud			FIG. 43
and dust collection port. For best results,
connect a vacuum to the port at the rear of the
saw.
After extended use, the saw’s dust collection
system may become clogged. To clear the
dust collection system:
1.	Unplug the saw.
2.	Turn the saw on its side, so the bottom,
	open part of the unit is accessible.	UU	VV
3.	Open the dust access door (UU) shown
	in Figure 43 by removing the wing screws
	(VV). Clean out the excess dust, and re-secure the access door with the wing screws.

Accessories

WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only DEWALT recommended accessories should be used with this product.

If you need assistance in locating any accessory, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-DEWALT (1-800-433-9258) or visit our website www.DEWALT.com.

STORAGE (Fig. 45, 46)

1.Attach push stick (U) to fence.

2.Remove Blade guard assembly. See To Remove Blade guard assembly. Slide Blade guard assembly into brackets as shown.

3.Depress the stem (GG) on the anti- kickback FIG. 45

	assembly (Q) to allow the assembly to slide from the
	riving knife slot.
4.	Position anti-kickback assembly into the storage hole	A4
	as shown. While depressing stem (GG) slide the anti-
	kickback assembly across the storage slot (A4) and
	release pin to lock into place.
5.	Loosen the riving knife lock knob (YY, Fig. 25) Q	GG
	(minimum of three turns).

6.Push riving knife lock knob (YY) toward the riving knife as indicated by the yellow arrows on the knob to disengage riving knife lock pin.

7.Lift and slide the riving knife from saw.

8.Remove wingnut securing blade wrenches. Place riving knife onto post with blade wrenches and secure with wingnut.

U

FIG. 46

English

Lubrication

FIG. 44

Q

1. All motor bearings are permanently lubricated at the factory and no additional lubrication is needed.

2. The height adjustment gear may require periodic cleaning and lubrication (Fig. 44). If you have difficulty raising or lowering the blade, contact a DEWALT authorized service center.

FF

D

V

15