DeWalt DWE4559CN instruction manual FIG3, Wheel Mountin9 Accessories Attachments, Attach M Ents

Thesidehandleshouldbeusedasthesecondarygripsurfaceforall otherapplications.

FIG3. \

3.Reinstall screws to attach the gear case to the motor housing. Tighten screws to 20 in.-Ibs, torque. Overtightening could cause screws to strip.

Rotating the Rear Handle (Fig. 5)

Thegearcasegripmaybepurchasedat additionalcost.Please call 1-800-4-DEWALT(1-800-433-9258)or visit our website: www.dewalt.com.

Ro*a*in9 the Gear Case (Fig. 4)

For applications in which a tool will be FIG.4 dedicated for uses in edge grinding and finishing work, the gear case may be rotated 90 ° left or right of its original position.

1.Remove the four corner screws

attaching the gear case to motor housing.

2.Without separating the gear case from motor housing, rotate the gear case head to desired position.

NOTE: If the gear case and motor housing become separated by more than 1/8" (3.17 mm), the tool must be serviced and re-assembled by a DEiWALTservice center. Failure to have the tool serviced may cause brush, motor and bearing failure.

10

(D28499 ONLY}			FIG.5
1.	Unlock	the rear handle by	_90o
	pulling out the Handle Release		1
	Lever (L).
2.	Rotate	handle into available	6°°

0°, 30 °, 60°, or 90 ° position left OR right of center.

3.Push in the handle release lever.

4.Before turning the tool on, ensure that the handle is locked into a position and the handle release lever has returned to the original position flush with the tool housing.

Wheel Mountin9 Accessories and

Attachments

It is important to choose the correct guards, backing pads and flanges to use with grinder accessories. Refer to pages 11-13 for information on choosing the correct wheel mounting accessories.

ATTACH M ENTS

Attachments designed specifically for this grinder can be purchased through DEWALT dealers and DEWALT Factory Service centers.

9" Type 27 guard	D284939
9" Type 28 guard	D284938
7" Type 27 guard	D284937
5"-6" Type 11 flaring cup guard with flange	D284936
4" Type 11 flaring cup guard with flange	D284934