DeWalt DWE4559CN Safety iNSTRUCTiONS for, ALL Operations, Abrasivej Cuing-OffOperations, Service

5)SERVICE

a)Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power too/is maintained.

SAFETY iNSTRUCTiONS FOR

ALL OPERATIONS

Safety Warnings Common for Grinding,

Sandingj Wire Brushingj Polishing or

Abrasivej Cu_ing-OffOperations

a)This power tool is intended to function as a grinder, sander, wire brush, polisher or cut-off tool Read all safety

warnings, instructions, illustrations and specifications provided with this power tool Failure to follow a//instructions listed below may result in electric shock, fire and/or serious injury.

b)Do not use accessories which are not specifically

designed and recommended by the tool manufacturer. Just because the accessory can be attached to your power tool, it does not assure safe operation.

c)The rated speed of the accessory must be at least equal to the maximum speed marked on the power tool Accessories running faster than their rated speed can break and fly apart.

d)The outside diameter and the thickness of your accessory must be within the capacity rating of your power tool Incorrectly sized accessories cannot be adequately guarded or controlled.

e)The arbor size of wheels, flanges, backing pads or any other accessory must properly fit the spindle of the power tool Accessories with arbor holes that do not

match the mounting hardware of the power too/wi//run out of balance, vibrate excessively and may cause loss of control.

f)Do not use a damaged accessory. Before each use inspect the accessory such as abrasive wheels for chips and cracks, backing pad for cracks, tear or excess wear,

wire brush for loose or cracked wires, if power tool or accessory is dropped, inspect for damage or install an undamaged accessory. After inspecting and installing an accessory, position yourself and bystanders away from the plane of the rotating accessory and run the power tool at maximum no-load speed for one minute. Damaged accessories will normally break apart during this test time.

g) Wear personal protective equipment. Depending on

application, use face shield, safety goggles or safety

glasses. As appropriate, wear dust mask, hearing

protectors, gloves and workshop apron capable of stopping small abrasive or workpiece fragments. The eye protection must be capable of stopping flying debris generated by various operations. The dust mask or respirator must be capable of filtrating particles generated by your operation. Prolonged exposure to high intensity noise may cause hearing loss.

h)Keep bystanders a safe distance away from work area. Anyone entering the work area must wear personal

protective equipment. Fragments of workpiece or of a broken accessory may fly away and cause injury beyond immediate area of operation.

i)Hold power tool by insulated gripping surfaces only,

when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock.