DeWalt DWE4559CN instruction manual Save These iNSTRUCTiONS for, Future USE

_ WARNING: ALWAYS use safety glasses. Everyday eyeglasses are NOT safety glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT_

•ANSI Z87.1 eye protection (CAN/CSA Z94.3), ANSI $12.6 ($3.19) hearing protection,

•NIOSH/OSHA/MSHA respiratory protection.

_WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of Califomia to cause canced birth defects or other reproductive harm. Some examples of these chemicals are:

lead from lead-based paints,

crystalline silica from bricks and cement and other masonry products, and

arsenic and chromium from chemically-treated lumbe_

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

Avoid prolonged contact with dust from power sanding,

sawing, grinding, drilling, and other construction

activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.

A WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.

i_ WARNING: Always wear proper personal hearing protection

that conforms to ANSI $12.6 ($3.19) during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.

The label on your tool may include the following symbols. The

symbols and their definitions are as follows:
V	volts	A	amperes
Hz	hertz	W	watts
min	minutes	............	altemating	current
....	. .... direct current	,_	altemating	or direct
(_)	Class I Construction		current
	(grounded)	no	no load speed
[]	Class II Construction	n	rated speed
	(double insulated)	.............	earthing terminal
.../min...	per minute	i_	safety alert symbol
IPM	impacts per minute	BPM	beats per minute
SPM	strokes per minute	RPM	revolutions per
sfpm	surface feet per		minute
	minute

SAVE THESE iNSTRUCTiONS FOR

FUTURE USE

Motor

Be sure your power supply agrees with the nameplate marking. Voltage decrease of more than 10% will cause loss of power and overheating. DEWALT tools are factory tested; if this tool does not operate, check power supply.