2.Remove M4x.7x10mm pan head screws, M4.1 flat washers and M4x.7 hex nuts from two holes (A) Fig. 7 in switch.
3.Insert switch assembly (C) Fig. 7 from the inside of the stand. Align the holes (A) in the switch with the holes in the stand (A) Fig. 8.
4.Place a M4.1 flat washer onto a M4x.7x10mm pan head screw. Insert screw through hole (A) in stand and switch. Thread a M4x.7 hex nut onto screw. Repeat this process for the remaining hole in stand and switch.
JOINTER TO STAND
Jointer weight is approximately 175 lbs. Care must be taken when moving it. A minimum of two people will be required to lift the ma-
chine.
1.Turn jointer upside down so it lays flat. One way to do this is to place the jointer table onto two wooden 4x4s as shown in Fig. 9A.
2.Turn the stand upside down and align the threaded holes in the bottom of the jointer with the holes in the stand, two of which are shown at (A) Fig. 9B. The infeed end of the jointer is fastened to the stand through these two holes (A) Fig. 9B and (A) fig. 9C. The outfeed end of the jointer is fastened to the stand through hole (B) Fig. 9C.
Fig. 8
A
Fig. 9A
Fig. 9B
A
BC
Fig. 9C
A
10 - English
