ADJUSTING FENCE POSITIVE STOPS
The fence on this jointer is equipped with positive stops that allow you to rapidly tilt the fence to the 90 and 45 degree angle to the table in the inward or outward position. To check and adjust the positive stops, proceed as follows:
Fig. 50
E
B 
1. | Position the fence at 90 degrees to the table. Make |
| certain the end of plunger (A) Fig. 50, is engaged |
| in notch (B) in index collar as shown, and tighten |
| lockhandle (C). |
2. | Place a square (D) Fig. 51, on the table and against |
| the fence and check if fence is 90 degrees to table. |
3. | If an adjustment is necessary, loosen set screw (E) |
| Fig. 50, in the index collar and loosen fence locking |
| handle (C). |
4. | Using the 90 degree edge of the square, tilt the fence |
| until you are certain the fence is 90 degrees to the |
| table and tighten lockhandle (C) Fig. 50, and set |
| screw (E). |
5. | Loosen lockhandle (C) Fig. 52, pull out and turn |
Fig. 51
Fig. 52
AC
D
C A
| plunger (A) and tilt fence out as far as it will go. Then |
| tighten lock handle (C). |
6. | Using square (D) Fig. 52, check to see if the fence |
| is at a 45 degree outward angle from the table, as |
| shown. |
7. | If an adjustment is necessary, loosen lockhandle (C) |
| Fig. 52. Loosen locknut (F) and turn adjusting screw |
| (G) until fence is tilted 45 degrees outward. Then |
| tighten locknut (F). |
8. | Loosen lockhandle (C) Fig. 53, and tilt fence inward |
| as far as possible, as shown, and tighten lockhandle |
| (C). |
9. | Using a square (D) Fig. 53, check to see if the fence |
| is at a 45 degree inward angle to the table, as shown. |
10.If an adjustment is necessary loosen locknut (J) Fig. 54, and turn adjusting screw (H) until fence is tilted 45 degrees in. Then tighten lock nut (J).
G
F
D
C
Fig. 53
D
Fig. 54
H
J
