3.Using the supplied wrench (or a 14 mm socket wrench), fasten the jointer to the top of stand using the three M10.2 lockwashers and three special studs. Two of the special studs are shown at (D) Fig. 10. These are for the infeed end of the machine. The other special stud is shown at (D) Fig. 11, for the outfeed end of machine. Fully tighten the studs at this time.
4.Once the jointer is completely secured to stand, stand the machine upright. (Jointer is shown upright and fully assembled in Fig. 11A.)
5.Push downward on the top of jointer until the stand adjusts to the floor surface. Then using the supplied wrench, tighten all stand hardware.
Fig. 10
D
D
Fig. 11
Fig.11A
