ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire instruction manual.

ASSEMBLY TOOLS REQUIRED

*6mm Allen Wrench

*4mm Allen Wrench

*3mm Allen Wrench

*2.5mm Allen Wrench

*12x14mm Open End Wrench

*8x10mm Open End Wrench (All are supplied.)

ASSEMBLY TIME ESTIMATE - 2-3 hours

STAND

1.Assemble stand as shown in Fig. 5 using parts shown in Fig. 4. The parts for the stand (as shown in Fig. 4) are:

5.Two Top End Braces for Stand (11-3/4")

6.Two Top Side Braces for Stand (15-3/4")

7.Two Lower Side Braces for Stand (20-1/2")

8.Two Lower End Braces for Stand (16-1/2")

9.Four Legs for Stand

10.Four Feet for Stand Legs

To assemble, insert the 5/16-18x3/4" carriage head bolts through legs and braces then place the 5/16" flat washers on the bolts and secure with the 5/16-18 hex nuts. Only tighten nuts finger-tight at this time. IMPORTANT: The top lips of two upper end braces

(5) Fig. 5, must fit on top of the top lips of two upper side braces (6).

2.Assemble four rubber feet (10), to the bottom of each leg (9) as shown.

DUST CHUTE TO STAND

1.The front of the stand is indicated by switch opening

(B)Fig. 6, making the outfeed end of the stand (C) and the infeed end (A).

2.Assemble dust chute (E) Fig. 6, to outfeed end of stand (C) as shown. Align the four holes (D) Fig. 6, in the dust chute with the four holes in the stand. Insert a 5/16-18x3/4" carriage bolt through the hole in the dust chute and stand. Place a 5/16" flat washer onto the screw and thread a 5/16-18 hex nut onto the screw. Repeat this process for the three remaining holes in the dust chute and stand. Only tighten hex nuts fingertight at this time.

MOTOR AND SWITCH TO STAND

1.Assemble motor (B) Fig. 7, to the bottom of the dust chute. Align the four holes (F) Fig. 7, in the dust chute, with the four holes in the motor mounting plate. Insert a 5/16-18x1¼"carriage bolt through hole in dust chute and hole in motor mounting plate. Place a 5/16" flat washer on screw and secure with a 5/16-18 hex nut. Repeat this process for the three remaining holes. Do not completely tighten hex nuts at this time as the motor must be adjusted for proper alignment and belt tension later.

6

5

5

7

6

8

 

8

7

 

9

 

 

 

10

 

Fig. 5

 

C D

D

E A

D B

Fig. 6

Fig. 7

F

A

D

C

FB

9 - English

Page 9
Image 9
DeWalt JT360 instruction manual Assembly Tools Required, Dust Chute to Stand, Motor and Switch to Stand