G586SP/G586SP AIO
49
different setting than indicated in Setup. Determine which
setting is correct, and then either turn off the system and
change the jumper, or enter Setup and change the VIDEO
selection.
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT
Since last powering off the system, the display adapter has
been changed. You must configure the system for the new
display type.
ERROR ENCOUNTERED INITIALIZING HARD
DRIVE
Hard drive cannot be initialized. Be sure the adapter is
installed correctly and all cables are correctly and firmly
attached. Also, be sure the correct hard drive type is selected
in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the card is correctly
and firmly installed in the bus. Be sure the correct hard drive
type is selected in Setup. Also, check to see if any jumper
needs to be set correctly on the hard drive.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR
PRESENT
Cannot find or initialize the floppy drive controller. Make
sure the controller is installed correctly and firmly. If no
floppy drive is installed, be sure the Diskette Drive selection
in Setup is set to NONE.
MEMORY SIZE HAS CHANGED SINCE LAST BOOT
Memory has been added or removed since the last boot.
Enter Setup and enter the new memory size in the memory
fields.
MEMORY VERIFY ERROR AT...
Indicates an error verifying a value already written to
memory. Use the location along with your system’s memory
map to locate the bad chip.