Diamondback 460 manual Heart Rate Monitoring, Pulse Hand Grips Standard, Chest Strap Optional

Heart Rate Monitoring

Pulse Hand Grips (Standard)

The 460 Model units have heart rate feedback and come standard with stainless steel pulse hand grips. To activate, gently grasp both hand grips to obtain a heart rate reading.

(Note: It is recommended to wear a chest strap for Heart Rate control program as it is more accurate. If you wear a chest strap and use hand grips at the same time for heart rate monitoring, the console will take the measurement of the chest strap.)

Pulse Grip Operating Tips:

If you are not getting a consistent reading while using the hand pulse option, we recommend the following suggestions:

•Make sure that the palms of the hands are touching the contact area of each hand pulse grip.

•Maintain an even pressure on the grips.

•Do not hold the hand pulse grips too tightly.

Chest Strap (Optional)

The 460 Model units are also equipped with a built-in receiver for your heart rate monitoring. To utilize this receiver you will need to wear a heart rate monitoring chest strap which is Polar® compatible. To get an accurate reading using these devices, you will need to be within three feet of the console, and a minimum of four feet from others who are using a heart rate monitoring device.

(Note: The transmitter may fluctuate erratically if you are too close to other heart rate monitoring equipment.)

The receiver of the wireless ECG system is built into the console of the Diamondback 460 equipment. When using any heart rate control program, the computer monitors and attempts to control your heart rate to the desired level. Heart rate frequency is displayed while the computer continually compares heart rate to the preprogrammed personal data. The computer adjusts wattage (load) to maintain heart rate at the preprogrammed level.

How to Wear Your Sensor/ Transmitter

1.Buckle one end of the chest strap onto the transmitter.

2.Adjust the band length so that the fit is snug, but not too tight.

3.Buckle the other end of the chest strap onto the transmitter.

4.Center the transmitter on your chest below the pectoral muscle (breasts).

5.Pull unit away from chest by stretching the belt and moistening the conductive electrode strips located next to the buckles.

(Note: The transmitter is on automatically when being worn. It is off when it is not connected to your body. However, as moisture may activate the transmitter, thor- oughly dry the transmitter to prolong battery life.)

16	f
	460 Series Owner’s Manual