| 2004 Bay Collection |
| Owner’s Manual |
Spa Check Up | When “SPA CHECK UP” is displayed on the Digital Display Window, we |
| recommend that you have your hot tub inspected by your dealer as a |
| preventative maintenance measure. |
| To reset this message, push and hold the Dimension One Spas |
| ICON (logo)→ Button located at the right hand side of the |
| control for 3 seconds. |
|
|
| The system can dismiss and reset the maintenance messages by pushing and holding the |
| Dimension One Spas ICON (logo)→, on the right end of the control, for 3 seconds. If you |
| press the Dimension One Spas ICON (logo)→ for 5 seconds when there is no |
| maintenance message, it will put the spa in the “Standby” mode. |
|
|
Overheat
Flashing Display and/or “Check Water Level”
Erroneous Temperature on the Display
DO NOT ENTER THE WATER when “OVERHEAT” is displayed on the control system Digital Display Window because the hot tub is in a high temperature condition. If such a condition exists, check the water temperature with a certified thermometer and if it is above 104° F (≅40° C), remove the hot tub cover and allow the water to cool. If the problem recurs, turn off all power to the hot tub and contact your local Authorized Dimension One Spas Dealer, or authorized service center.
The overheat condition could be caused by excessive filtration. See the Troubleshooting Guide section for more information.
DO NOT ENTER THE WATER if you see “3 flashing LEDs” on the Top Side Control and/or the message, “CHECK WATER LEVEL
Check the water temperature and if it is above 104° F (≅40° C) and DO NOT ENTER THE WATER.
DO NOT ENTER THE WATER if you see a temperature reading of 32°
F(≅0° C) or 136° F (≅57.8° C) without first checking the actual water temperature with a separate thermometer. The system has detected a Temperature Probe Failure and the water may be too hot, or too cold, to safely use.
Contact your local Authorized Dimension One Spas Dealer, or authorized service center.
30
