2004 Bay Collection
Owner’s Manual
14.Once the spa is full, turn on the circuit breaker (not supplied by Dimension One Spas). Flashing dashed lines will appear for 30 seconds on the Digital Display Window followed by the current water temperature (flashing).
15.Push the Jet Pump 3 Button once to turn on Pump 3. Let the system run for 10 to 15 seconds to prime the pump.
16.Then push the Jets Button on the Dynamic Massage Sequencer to the right of the Top Side Control to start Pump 1. Let it run for 10 to 15 seconds to prime Pump 1. Press the button again to shut the pump off.
17.Then push the Jets Button on the Dynamic Massage Sequencer to the left of the Top Side Control to start Pump 2. Let it run for 10 to 15 seconds to prime Pump 2. Press the button again to shut the pump off.
18.If there is no jet action, then the water level is too low or there is air trapped in the plumbing lines. To eliminate the trapped air, turn the pumps on and off several times to force the trapped air through the pumps. If there is still no jet action, and the bleeder valves were removed as previously described, turn off the pumps and loosen the top pump unions slightly to let any trapped air escape.
Ozone bubbles will continue to release from the skimmer recess UltraPure™ bleeder valve as long as the valve remains open. Once the pumps are primed, be sure that the bleeder is closed tightly.
19.When the jets are in full operation, replace and close the bleeder valves and push the UP/Down Buttons until your desired water temperature (set temperature) is indicated on the Digital Display Window. The Digital Display Window will then display your set temperature for thirty seconds before changing to display the current water temperature.
57
