Summer Mode
Standby Mode
2003 Sarena Bay™
Export Owner’s Manual
The “SUMMER MODE” feature temporarily disables the circulation pump “Cool Off” cycle. During hot weather the spa can experience “Heat Creep”. Heat creep is caused when the spa, during normal maintenance operations, cannot dissipate more heat than is generated. This may cause the spa temperature to exceed the set temperature and cause a “Cool Off” cycle. In order to prevent the water from becoming cloudy due to the circulation pump being turned off by the “Cool Off” cycle, the spa can be set to bypass the “Cool Off” cycle. This is accomplished by setting the spa in the “SUMMER MODE”.
To initiate a “SUMMER MODE”, use the Up and Down Buttons to set the temperature to 15°C (≅59° F). The Digital Display Window will indicate “SUMMER MODE”. In this mode the pump will run continuously until the water temperature reaches 41° C (≅107°F) and then turn off. It will remain off until the water temperature reaches 38° C (≅102° F) at which point the pump turns on.
The “STANDBY” mode allows the user to clean the filter without turning off power to the spa. This feature disables all automatic and manual functions.
To enter the “STANDBY” mode press and hold the Dimension One Spa’s ICON Logo→ Button for 5 seconds. To exit the mode, press and hold the Logo Button for 5 seconds.
If you do not exit the mode manually, the spa will automatically return to normal functionality after 24 hours.
The “Smart Winter” mode is not affected by the use of the “Standby”: mode.
Note
Programming the Scrolling Message Center
Your Scrolling Message Center is the most advanced in the industry and can virtually walk you through customizing your hot tub to your exact needs. To initiate the programming sequence at any time, push and hold the Program Button for 3 seconds. If, within 10 seconds, you do not proceed with the hot tub programming, the hot tub will automatically exit the programming sequence and revert to the
Setting the Time
After holding the PROGRAM Button, the top line of the Digital Display Window will read “SET TIME OF DAY” and the bottom line will read “PUSH UP OR DOWN TO CHANGE - PUSH PROGRAM TO SELECT NEXT FUNCTION - PUSH ENTER TO EXIT ”. Push the UP or DOWN Buttons to engage the time setting mode. The time screen will appear with “hours” (_ _.00) flashing on and off. Push the UP or DOWN Button to increase or decrease the number until the desired hour appears. When the desired number is displayed, push the LIGHT Button to accept the selection and change the flashing number to the “ten minute” place (12:_0). Adjust the number with the UP or DOWN Button in the same manner as the hour number. When the desired indicator is displayed, push the LIGHT Button to accept the selection and change the flashing number to the “minute” place (12:1_). Adjust this number with the UP or DOWN
28
