2003 Sarena Bay™
Export Owner’s Manual
Zone F
This zone is designed to massage the feet. There are two rotating mini Euro Jets→ that are water volume controllable and provide a narrowly focused massage pattern. These jets are interchangeable with directional jets.
Operating the Dynamic Massage Sequencer
Push the JETS Button to turn on the spa pump.
Select the sequence you want by using the SEQUENCE Button to toggle between the selected massage sequences. When the sequence you desire shows an illuminated SEQUENCE Indicator Light (1 through 6), press the BEGIN/PAUSE Button to activate the massage sequence.
SEQUENCE #1 activates individual zones and steps through them – one at a time, starting with Zone A through Zone F, then reverses the sequence. The time interval between zones is determined by the Speed Button.
SEQUENCE #2 functions opposite of #1 above. This sequence activates all zones, then deactivates individual zones and steps through them – one at a time, starting with Zone A through Zone F, then reverses the sequence. The time interval between zones is determined by the Speed Button.
SEQUENCE #3 activates alternate zones. It sequences Zones A, C, and E first, then switches to Zones B, D, and F second. The time interval between Zone Groups is determined by the Speed Button.
SEQUENCE #4 activates individual zones and steps through them – one at a time, starting with Zone A through Zone F, then it starts over in groups of two zones – incrementing the zones (i.e. Zones A,B; Zones B, C, etc.). The time interval between Zone Groups is determined by the Speed Button.
SEQUENCE #5 starts with Zone A and adds a new zone during each step in the sequence until all zones are active. Then it reverses the sequence by removing a zone during each sequence step until all zones have been removed. The time interval between Zone Groups is determined by the Speed Button.
SEQUENCE #6 provides random groupings of two zones, starting with adjacent zones, (i.e. Zones A,B; then Zones B,C; etc), then opposite zones (i.e. Zones A,F; then Zones B,F; etc.); and finally the middle zones (i.e. Zones B,E; then Zones C,D, etc.). The time interval between Zone Groups is determined by the Speed Button.
If the time between sequence changes is too fast or too slow, you can push the SPEED Button to increase or decrease the time between sequence changes. Five seconds is default. Other speeds available are 15 and 30 seconds.
Note
35
